Rendering Pre-Breaker Model Is JSPSA-1226-03 Rendering Plant Crusher

Main Features:

1) low speed axis can handle metals in raw materials.

2) equipped with electronic speed monitoring, the motor can be stopped immediately when large matter enter the crusher.

3) the spindle is equipped with heavy roller bearings, which can resist large radial and axial impact.

4) standard parts are used for driving from motor to shaft.

5) localized structures can replace parts in a short time.

6)the material inlet and outlet are equipped with standard removable butt flanges.

Influencing factors

Generally speaking, there are many factors that affect the production capacity of impact crushers. Generally speaking, there are such five factors. Below I will describe these five factors and propose corresponding solutions.

1. The hardness of the material: the harder the material, the more difficult it is to make sand, and the more severe the wear on the impact crusher. The sand making speed is slow and the ability is low. Therefore, we need to pay attention to the selection of materials. [5]

2. Material composition: The more fine powder contained in the material before the impact crusher, the more it will affect sand making, because these fine powders are easy to adhere and affect transportation. Therefore, materials with high fine powder content should be screened in advance. Filter the fine powder from the material as much as possible so as not to affect the normal operation of the impact crusher.

3. The fineness of the material after the impact crusher is crushed: the fineness requirement is high, that is, the finer the material required to make sand, the smaller the sand making capacity. This aspect depends on the specific requirements. If there is no special requirement, the fineness of the material is generally set to medium fine.

4. Material viscosity: the higher the material viscosity, the easier it is to adhere. The material with high viscosity will adhere to the inner wall of the sand making cavity in the impact crusher. If it cannot be cleaned in time, it will affect the working efficiency of the impact crusher, and in severe cases, it may also affect the normal operation of the vertical crusher. Therefore, when selecting materials, we must pay attention to the viscosity of the materials not too high.

5. The humidity of the material: When the moisture in the material is large, the material is easy to adhere in the vertical crusher, and it is also easy to cause blockage during the feeding and conveying process, resulting in the reduction of sand making capacity. To solve this problem, firstly, when selecting materials, we must strictly control the humidity of the materials. If the humidity of the selected materials is too high, sunlight or air drying can be used to reduce the percentage of moisture in the materials.

Jiangsu SunRise Environmental Technology Co., Ltd. is located in Xuzhou, the beautiful capital of construction machinery. Founded in 2016, it is a comprehensive environmental protection company focusing on animal protein and grease recycling, food waste treatment, and sludge reduction treatment as a technology company.

The company has the most advanced technology and technology in the industry, more than 20 engineers, more than 100 technicians, and a standard factory building of 20,000 m2. The company was rated as a top high-tech enterprise in 2018. The main body of the team is a group of young people with ideals, aspirations, and innovation, with an average age of 35. We will rely on the unremitting efforts of all employees to develop domestic and foreign markets, and provide customers with advanced technology and Equipment, continue to create greater value for customers.